Dying shrimp
- plankton
- Super Mod
- Posts: 12251
- Joined: Sun Jan 21, 2018 17:02 pm
- Location: S. Derbyshire
- Has liked: 5051 times
- Been liked: 3423 times
Have you popped any cuttlebone in yet?
-
- Senior Member
- Posts: 327
- Joined: Sun Nov 29, 2020 10:44 am
- Location: Norfolk
- Has liked: 189 times
- Been liked: 124 times
Struggled to get some and what I got had a strange chemical smell to it, so didn’t risk putting it in. Will Equilibrium do the same as cuttlebone or should I try and get some more?
Got some Equilibrium so I’m going to slowly add it over the next few hours, testing GH and TDS as I go.
340 litre Aqua Oak
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
- plankton
- Super Mod
- Posts: 12251
- Joined: Sun Jan 21, 2018 17:02 pm
- Location: S. Derbyshire
- Has liked: 5051 times
- Been liked: 3423 times
You'll need some source of calcium for them to be able to moult properly......I doubt whether Equilibrium will provide that.
Does the cuttle still smell after you've boiled a piece for a couple of minutes (just pop it in some boiling water, you actually have to put it on a hob )?
Does the cuttle still smell after you've boiled a piece for a couple of minutes (just pop it in some boiling water, you actually have to put it on a hob )?
- Martinspuddle
- Forum Jester & TOTM Winner
- Posts: 7098
- Joined: Tue Dec 31, 2019 18:07 pm
- Location: Sceapig
- Has liked: 4245 times
- Been liked: 3908 times
I'm exporting my iron water to him, that will sort his problem out!
Last edited by Martinspuddle on Sat Sep 04, 2021 11:24 am, edited 1 time in total.
WARNING - DO NOT BREED, FEED OR PET THE PUDDLE!
--------------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------------------------------------------------
-
- Senior Member
- Posts: 327
- Joined: Sun Nov 29, 2020 10:44 am
- Location: Norfolk
- Has liked: 189 times
- Been liked: 124 times
It does have calcium in it, not sure if it’s what the shrimp need though.plankton wrote: ↑Sat Sep 04, 2021 8:09 am You'll need some source of calcium for them to be able to moult properly......I doubt whether Equilibrium will provide that.
Does the cuttle still smell after you've boiled a piece for a couple of minutes (just pop it in some boiling water, you actually have to put it on a hob )?
I can’t use the cuttlebone as I no longer have it. Don’t think I’d have been happy using it under any circumstances. I’ve got to go out shortly and there’s a pet shop nearby, so I’ll pop in and see if they have any.
I’ve been replacing a litre of tank water with a litre of Equilibrium about once an hour. This raises the GH a little to around 3-4GH but within an hour it’s back down to 2GH. What’s going on there?
340 litre Aqua Oak
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
-
- Senior Member
- Posts: 327
- Joined: Sun Nov 29, 2020 10:44 am
- Location: Norfolk
- Has liked: 189 times
- Been liked: 124 times
No cuttlebone at the pet shop. Ordered some from Amazon that will be here tomorrow, hopefully this stuff is good.
340 litre Aqua Oak
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
- plankton
- Super Mod
- Posts: 12251
- Joined: Sun Jan 21, 2018 17:02 pm
- Location: S. Derbyshire
- Has liked: 5051 times
- Been liked: 3423 times
Fingers crossed - I don't think the Seachem stuff will be enough.
-
- Senior Member
- Posts: 327
- Joined: Sun Nov 29, 2020 10:44 am
- Location: Norfolk
- Has liked: 189 times
- Been liked: 124 times
Got some cuttlebone and it’s been in a pan of boiling water, took half hour to sink. I scraped some to make a dust and dropped it in the tank, hopefully the shrimp will find some.
Unfortunately another dead shrimp today, only one left now. I really want some more but need to figure out what’s killing them first. Fingers crossed that the cuttlebone does the job and this last one survives.
Unfortunately another dead shrimp today, only one left now. I really want some more but need to figure out what’s killing them first. Fingers crossed that the cuttlebone does the job and this last one survives.
340 litre Aqua Oak
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
- fr499y
- Admin - TOTM Winner
- Posts: 8358
- Joined: Sun Jan 28, 2018 16:04 pm
- Location: West Midlands
- Has liked: 1785 times
- Been liked: 4203 times
Break a chunk of the boiled cuttle fish into the tank. Only a small bit ( say an inch )
-
- Senior Member
- Posts: 327
- Joined: Sun Nov 29, 2020 10:44 am
- Location: Norfolk
- Has liked: 189 times
- Been liked: 124 times
Done. Thanks.
340 litre Aqua Oak
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose
Fluval FX-4
Fluval Aquasky 2.0
Fluval Plant 3.0
Aquael Platinum 300W heater
4 x Angels (2 x breeding pairs)
6 x Gold Pristella Tetra
7 x Pristella Tetra
1 x Cardinal Tetra
1 x Female Rainbow Stiphodon Goby
8 x Sterbai Corys
6 x Ottocinclus
3 x Bristlenose